Alpine PSS-22WRA Weatherproof Direct fit Complete Speaker System for 2011-2018 4 Door Wrangler JK
Picture this. You’re out to eat after a long beautiful day at the beach. You start to notice the skies turn grey and you get that feeling when you know it’s about to rain. You’ve got a weatherproof head unit with either the i209-WRA or the X209-WRA, so why should you still fear that your speakers, amp, and sub could get damaged. Well, fear no more! Introducing the Alpine PSS-22WRA Weatherproof complete speaker system for the Wrangler JK. Not only can this speaker system handle the elements, but it packs a punch too. With a 10″ Subwoofer, a Four Channel Amp, two sets of Wrangler specific 6.5″ Component speakers, and a monotube amp with remote bass knob, you know you got your money’s worth.
2x SPV-65X-WRA 6-1/2″ Component Speakers:
CTA-2031 Power Rating: 75W RMS, 225W Peak
Nominal impedance 4 Ohm
Frequency response 65-22kHz
1″ Teteron dome tweeter
Steel frame with factory speaker mounting tabs
Weather resistant: IP55
Includes vehicle specific speaker connectors
KTA-30FW:
Alpine’s Class D amplifier circuit with Dynamic Peak Power (D.P.P.)
Weather resistant (IP66 rating)
150W x 4 D.P.P. (2Ω/4Ω, 14.4V, ≤ 1% THD+N)
CTA-2006-B Specifications: 75W RMS x 4 (2Ω/4Ω, 14.4V, ≤ 1% THD+N)
82dB S/N (ref. 1W into 4Ω)
>0.05% THD
Hi Resolution Audio Ready
OEM-grade Tyco 26-pin connector with pigtail wire harness
Speaker/RCA inputs (Selectable, High range=0.5-10V, Low range=0.2-4V)
SBV-10-WRA
10-inch subwoofer pre-loaded into a sealed, custom-fit enclosure
Designed to be pressure fit under the front passenger’s seat rails, no mounting hardware is required
Trail Ready – Rated at IP66 for protection against total dust ingress and water from any direction
OEM-grade weather resistant Molex 2-pin connector with pigtail wire harness
Nominal Impedance: 2 ohm
Frequency Response: 45-200Hz
The 300W RMS/900W max power rating is a match for the KTA-30MW Mono Tough Power Pack Amplifiers
KTA-30M-WRA
Class: D
Dynamic Pulse Power (DPP) Equipped: Yes
Power: 600W DPP x 1 @ 2Ω, 14.4V, ≤1% THD+N
Root Mean Squared: 300W RMS x 1 @ 2Ω, 14.4V, ≤1% THD+N (CTA-2006-B compliant)
Signal to Noise (1W into 4Ω): >83dB
THD (ref. 1W into 4Ω): <0.1%
Frequency Response: 20-400kHz (+/- 1dB)
Waterproof Rating: IP66 rating
Inputs: Speaker/RCA inputs (selectable, High range=0.5-10V, Low range=0.2-4V)
Sound Control: LP filter - Off/LP, Fc = 50-400Hz @ -24dB/Oct. (variable); Input gain settings (variable); Bass EQ: 0 to +12dB, Fc = 50Hz (variable)
*NOTE* The Alpine 10" Water Resistant Subwoofer is designed for use with factory carpet. If your Jeep does not have carpets, additional padding may be required.
